Over 15 years experience of providing support of MEAN WELL Power Supplies
Overview
RS-15-3.3 is the 3.3V output model of this series: rated current 3A, rated power 9.9W, typical efficiency 72%.
Features
- Universal AC input / Full range
- Protections: Short circuit / Overload / Over voltage / Over temperature
- Cooling by free air convection
- LED indicator for power on
- 100% full load burn-in test
- No load power consumption<0.5W
- All using 105℃ long life electrolytic capacitors
- Withstand 300VAC surge input for 5 second
- High operating temperature up to 70℃
- Withstand 5G vibration test
- High efficiency, long life and high reliability
- 3 years warranty
Specifications
OUTPUT
- DC VOLTAGE
- 3.3V
- RATED CURRENT
- 3A
- CURRENT RANGE
- 0 ~ 3A
- RATED POWER
- 9.9W
- RIPPLE & NOISE (max.)Note.2
- 80mVp-p
- VOLTAGE ADJ. RANGE
- 2.9 ~ 3.6V
- VOLTAGE TOLERANCENote.3
- ±3.0%
- LINE REGULATIONNote.4
- ±0.5%
- LOAD REGULATIONNote.5
- ±2.0%
- SETUP, RISE TIME
- 1000ms, 30ms/230VAC 1000ms, 30ms/115VAC at full load
- HOLD UP TIME (Typ.)
- 70ms/230VAC 12ms/115VAC at full load
INPUT
- VOLTAGE RANGE
- 85 ~ 264VAC 120 ~ 370VDC
- FREQUENCY RANGE
- 47 ~ 63Hz
- EFFICIENCY (Typ.)
- 72%
- AC CURRENT (Typ.)
- 0.35A/115VAC 0.25A/230VAC
- INRUSH CURRENT (Typ.)
- COLD START 65A / 230VAC
- LEAKAGE CURRENT
- <2mA / 240VAC
PROTECTION
- OVERLOAD
- Above 105% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed
- OVER VOLTAGE
- 3.8 ~ 4.45V Protection type : Shut off o/p voltage, clamping by zener diode
- OVER TEMPERATURE
- Shut down o/p voltage, recovers automatically after temperature goes down
ENVIRONMENT
- WORKING TEMP.
- -20 ~ +70℃ (Refer to "Derating Curve")
- WORKING HUMIDITY
- 20 ~ 90% RH non-condensing
- STORAGE TEMP., HUMIDITY
- -40 ~ +85℃, 10 ~ 95% RH
- TEMP. COEFFICIENT
- ±0.03%/℃ (0 ~ 50℃)
- VIBRATION
- 10 ~ 500Hz, 5G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY & EMC (Note 6)
- SAFETY STANDARDS
- UL62368-1, TUV BS EN/EN62368-1 , AS/NZS 62368.1, EAC TP TC 004, CCC GB4943.1, BSMI CNS15598-1, BIS IS13252(Part1):2010/IEC 60950-1: 2005 approved
- WITHSTAND VOLTAGE
- I/P-O/P:3KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC
- ISOLATION RESISTANCE
- I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25℃/ 70% RH
- EMC EMISSION
- Compliance to BS EN/EN55032 (CISPR32) Class B, BS EN/ EN61000-3-2,-3,GB9254 class B,GB17625.1, EAC TP TC 020, CNS15936 Class B
- EMC IMMUNITY
- Compliance to BS EN/EN61000-4-2, 3, 4, 5, 6, 8,11, BS EN/EN55035, BS EN/EN61000-6-1, light industry level, EAC TP TC 020
OTHERS
- MTBF
- 4914.9K hrs min. Telcordia SR-332 (Bellcore) ; 1608.9K hrs min. MIL-HDBK-217F (25℃)
- DIMENSION
- 62.5*51*28mm (L*W*H)
- PACKING
- 0.13Kg; 108pcs/15Kg/0.8CUFT
Test conditions and notes7
- 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
- 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1μF & 47μF parallel capacitor.
- 3. Tolerance : includes set up tolerance, line regulation and load regulation.
- 4. Line regulation is measured from low line to high line at rated load.
- 5. Load regulation is measured from 0% to 100% rated load.
- 6. The power supply is considered a component which will be installed into a final equipment. All the EMC tests are been executed by mounting the unit on a 230mm*230mm metal plate with 1mm of thickness. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to “EMI testing of component power supplies.” (as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf )
- 7. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
Technical drawings
Downloads
FAQ
Can I use the RS-15-3.3 for a 3.3V PLC or embedded control board?
Yes, this model is a constant-voltage 3.3V supply rated for up to 3A. That makes it suitable for 3.3V control electronics, embedded boards, and low-power automation circuits that stay within its 9.9W output rating.
Is the RS-15-3.3 a good fit for industrial sensors and logic-level electronics?
It can be a fit for 3.3V sensor hubs, logic circuits, and compact industrial electronics that need a regulated 3.3V output. Buyers should match the total load to the unit's 3A and 9.9W limits.
Can this power supply run a small embedded HMI or single-board controller that uses 3.3V power?
It is intended for low-power 3.3V equipment, so it can work for compact embedded controllers or interface boards that require constant-voltage 3.3V input. The key limit is available output current, which is 3A.
Is the RS-15-3.3 suitable for vibration-prone machine enclosures?
The specifications list 5G vibration (10-500Hz, X/Y/Z axes) and operation up to +70°C with derating per the derating curve. That makes it a reasonable option for protected industrial control enclosures where vibration resistance matters and the load stays within 9.9W.
Can the RS-15-3.3 be used outdoors or in hot equipment cabinets?
The operating temperature range is -20°C to +70°C, with output derating at higher ambient temperatures per the derating curve, so it is designed for a wide temperature span inside equipment. The provided specs do not list an IP rating, so it is better suited to protected indoor enclosures rather than exposed outdoor locations.
Payment & Security
Payment methods
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
Other RS-15 Models
2 other models| Model | Power | Voltage | Current | |
|---|---|---|---|---|
| Mean Well RS-15-5 Power Supply 15W 5V 3A | 15W | 5V | 3A | View |
| Mean Well RS-15-12 Power Supply 15W 12V 1.3A | 15.6W | 12V | 1.3A | View |
Please log in to write a review.
Write a review
Reviews are checked before publishing. By submitting you confirm this is your genuine experience with this product.
Submitting your review…
It's published and now helps other buyers.
We're checking it and it'll appear shortly.
Please try again.







