Over 15 years experience of providing support of MEAN WELL Power Supplies
Overview
LPC-35-700 is the model of this series: rated current 700mA, rated power 33.6W, typical efficiency 85%.
Features
- Constant current design
- Universal AC input / Full range
- Withstand 300VAC surge input for 5 seconds
- Protections: Short circuit / Over voltage
- Cooling by free air convection
- Fully encapsulated with IP67 level (Note.6)
- Fully isolated plastic case
- Class Ⅱ power unit, no FG
- Class 2 power unit
- Pass LPS
- Display devices for decorative & advertising accessories (Note.9)
- 100% full load burn-in test
- Low cost, high reliability
- 2 years warranty
Specifications
OUTPUT
- RATED CURRENT
- 700mA
- CONSTANT CURRENT REGION
- 9 ~ 48V
- RATED POWER
- 33.6W
- CURRENT RIPPLENote.2
- ±5%
- VOLTAGE TOLERANCE
- ±5.0%
- CURRENT ACCURACY
- ±5.0%
- SETUP, RISE TIMENote.5
- 500ms, 120ms / 230VAC 500ms, 120ms / 115VAC at full load
- HOLD UP TIME (Typ.)
- 50ms/230VAC 16ms/115VAC at full load
INPUT
- VOLTAGE RANGENote.3
- 90 ~ 264VAC 127 ~ 370VDC
- FREQUENCY RANGE
- 47 ~ 63Hz
- EFFICIENCY (Typ.)
- 85%
- AC CURRENT (Typ.)
- 1.1A/115VAC 0.7A/230VAC
- INRUSH CURRENT(Typ.)
- COLD START 55A(twidth=500μs measured at 50% Ipeak) at 230VAC
- MAX. No. of PSUs on 16A CIRCUIT BREAKER
- 4 units (circuit breaker of type B) / 7 units (circuit breaker of type C) at 230VAC
- LEAKAGE CURRENT
- 0.25mA / 240VAC
PROTECTION
- OVER VOLTAGE
- 50.4 ~ 60V Protection type : Shut off o/p voltage, clamping by zener diode
ENVIRONMENT
- WORKING TEMP.
- -30 ~ +70℃ (Refer to "Derating Curve")
- WORKING HUMIDITY
- 20 ~ 90% RH non-condensing
- STORAGE TEMP., HUMIDITY
- -40 ~ +80℃, 10 ~ 95% RH
- TEMP. COEFFICIENT
- ±0.03%/℃ (0 ~ 50℃)
- VIBRATION
- 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY & EMC
- SAFETY STANDARDS
- UL1310, CAN/CSA C22.2 No. 223-M91(except for LPC-35-700), BIS IS15885, IEC62368-1,EAC TP TC 004, BS EN/EN62368-1, IP67 approved;
- WITHSTAND VOLTAGE
- I/P-O/P:3KVAC
- ISOLATION RESISTANCE
- I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH
- EMC EMISSION
- Compliance to BS EN/EN55032 (CISPR32) Class B, BS EN/EN61000-3-2 Class A, BS EN/EN61000-3-3, EAC TP TC 020
- EMC IMMUNITY
- Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, BS EN/EN55035, light industry level, EAC TP TC 020
OTHERS
- MTBF
- 6050.2K hrs min. Telcordia SR-332 (Bellcore) ; 574.4K hrs min. MIL-HDBK-217F (25℃)
- DIMENSION
- 148*40*30mm (L*W*H)
- PACKING
- 0.34Kg; 40pcs/14.6Kg/0.70CUFT
Certifications & ratings
- IP level
- IP67
- Marked features
- Class II
Test conditions and notes9
- 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
- 2. Current ripple is measured 60%~100% of maximum voltage under rated power delivery.
- 3. Derating may be needed under low input voltage. Please check the static characteristics for more details.
- 4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. (as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf)
- 5. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.
- 6. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute.
- 7. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
- 8. For any application note and IP water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf
- 9. This product is not intended for LED lighting luminaire applications in the EU and China.(In the EU and China the LPF/NPF/XLG/XLC/XLN series are recommended.)
Technical drawings
Downloads
FAQ
Can I use the LPC-35-700 for a 700mA LED downlight?
Yes, this driver is designed for constant current LED loads at 700mA. It is a fit for LED downlights that need 700mA and operate within the 9-48V constant current range, with total load power up to 33.6W.
Is the LPC-35-700 suitable for LED signage modules?
It can be suitable for signage modules if the module string is a constant current 700mA load and falls within the 9-48V CC output range. With an IP67 encapsulated design and 33.6W output, it suits indoor signage or outdoor signage that is not exposed to direct sunlight, unlike a non-waterproof indoor-only driver.
Can the LPC-35-700 run a small LED array?
Yes, if the LED array is designed for constant current operation at 700mA. The array's total forward voltage must stay within 9-48V and the total power must remain within 33.6W.
Will the LPC-35-700 work with my LEDs if I do not know the LED count yet?
This depends on the LED string's total forward voltage, not a fixed LED count. The driver supplies 700mA constant current across 9-48V, so the number of LEDs will vary based on each LED's forward voltage; it is not intended for constant voltage LED loads.
Is the LPC-35-700 okay for outdoor or harsh environments?
It is rated IP67 and has a working temperature range of -30°C to +70°C (with derating per the derating curve), so it handles wet or dusty environments when the rest of the fixture is rated appropriately. Outdoors it should be kept out of direct sunlight, and immersion in water for more than 30 minutes should be avoided.
Payment & Security
Payment methods
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
Please log in to write a review.
Write a review
Reviews are checked before publishing. By submitting you confirm this is your genuine experience with this product.
Submitting your review…
It's published and now helps other buyers.
We're checking it and it'll appear shortly.
Please try again.







