Over 15 years experience of providing support of MEAN WELL Power Supplies
Overview
HLG-120H-C350A is the model of this series: rated current 350mA, rated power 150.5W, typical efficiency 94%.
HLG-120H-C series is a 150W AC/DC LED driver featuring the constant current mode and high voltage output. HLG-120H-C operates from 90~305VAC and offers models with different rated current ranging between 350mA and 1400mA. Thanks to the high efficiency up to 94%, with the fanless design, the entire series is able to operate for -40℃ ~ +90℃ case temperature under free air convection. The design of metal housing and IP67/IP65 ingress protection level allows this series to fit both indoor and outdoor applications. HLG-120H-C is equipped with various function options, such as dimming methodologies, so as to provide the optimal design flexibility for LED lighting system.
Features
- Constant current mode output
- Metal housing with ClassⅠ design
- Built-in active PFC function
- IP67 / IP65 design for indoor or outdoor installations
- Function options: output adjustable via potentiometer; 3 in 1 dimming; Timer dimming
- Typical lifettime>62000 hours
- 7 years warranty
Specifications
OUTPUT
- RATED CURRENT
- 350mA
- RATED POWER
- 150.5W
- CONSTANT CURRENT REGIONNote.2
- 215 ~ 430V
- CURRENT ADJ. RANGE
- Adjustable for A/AB-Type only (via built-in potentiometer)
- CURRENT ADJ. RANGE
- 175 ~ 350mA
- CURRENT RIPPLE
- 8.0% max. @rated current
- CURRENT TOLERANCE
- ±5%
- SET UP TIMENote.4
- 1000ms / 115VAC 500ms / 230VAC
INPUT
- VOLTAGE RANGENote.3
- 90 ~ 305VAC 127 ~ 431VDC (Please refer to "STATIC CHARACTERISTIC" section)
- FREQUENCY RANGE
- 47 ~ 63Hz
- POWER FACTOR (Typ.)
- PF≧0.98/115VAC, PF≧0.96/230VAC, PF≧0.93/277VAC @full load (Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section)
- TOTAL HARMONIC DISTORTION
- THD< 20% (@ load≧50% /115VAC, 230VAC; @ load≧75%/277VAC) (Please refer to “TOTAL HARMONIC DISTORTION (THD)” section)
- EFFICIENCY (Typ.)
- 94%
- AC CURRENT (Typ.)
- 1.6A / 115VAC 0.8 A / 230VAC 0.7A / 277VAC
- INRUSH CURRENT(Typ.)
- COLD START 50A(twidth=600μs measured at 50% Ipeak) at 230VAC; Per NEMA 410
- MAX. No. of PSUs on 16A CIRCUIT BREAKER
- 4 units (circuit breaker of type B) / 6 units (circuit breaker of type C) at 230VAC
- LEAKAGE CURRENT
- <0.75mA / 277VAC
PROTECTION
- SHORT CIRCUIT
- Constant current limiting, recovers automatically after fault condition is removed
- OVER VOLTAGE
- 475 ~ 495V Shut down o/p voltage with auto-recovery or re-power on to recovery
- OVER TEMPERATURENote.7
- Shut down o/p voltage, recovers automatically after temperature goes down
ENVIRONMENT
- WORKING TEMP.
- Tcase=-40 ~ +90℃(Please refer to "OUTPUT LOAD vs TEMPERATURE" section)
- MAX. CASE TEMP.
- Tcase=+90℃
- WORKING HUMIDITY
- 10 ~ 95% RH non-condensing
- STORAGE TEMP., HUMIDITY
- -40 ~ +80℃, 10 ~ 95% RH
- TEMP. COEFFICIENT
- ±0.03%/℃ (0 ~ 50℃)
- VIBRATION
- 10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
SAFETY & EMC
- SAFETY STANDARDSNote.6
- UL8750, CSA C22.2 No. 250.13-12, BS EN/EN/AS/NZS 61347-1, BS EN/EN/AS/NZS 61347-2-13, BS EN/EN62384 independent, GB/T19510.1, GB/T19510.213, IP65 or IP67, J61347-1, J61347-2-13, EAC TP TC 004 approved
- WITHSTAND VOLTAGE
- I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:1.5KVAC
- ISOLATION RESISTANCE
- I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25℃/ 70% RH
- EMC EMISSIONNote.6
- Compliance to BS EN/EN55015, BS EN/EN61000-3-2 Class C (@ load≧50%) ; BS EN/EN61000-3-3,GB/T 17743 , GB17625.1, EAC TP TC 020
- EMC IMMUNITY
- Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, BS EN/EN61547, light industry level (surge immunity Line-Earth 4KV, Line-Line 2KV), EAC TP TC 020
OTHERS
- MTBF
- 2456.4K hrs min. Telcordia SR-332 (Bellcore) ; 191.1K hrs min. MIL-HDBK-217F (25℃)
- DIMENSION
- 220*68*38.8mm (L*W*H)
- PACKING
- 1.04Kg; 12pcs/13.5Kg/0.8CUFT
Test conditions and notes11
- 1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25℃ of ambient temperature.
- 2. Please refer to "DRIVING METHODS OF LED MODULE".
- 3. De-rating may be needed under low input voltages. Please refer to “STATIC CHARACTERISTIC” sections for details.
- 4. Length of set up time is measured at first cold start. Turning ON/OFF the driver may lead to increase of the set up time.
- 5. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. (as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf)
- 6. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED driver can only be used behind a switch without permanently connected to the mains.
- 7. For OTP which triggered at light load/no load condition, proceed AC repower on to recovery.
- 8. This series meets the typical life expectancy of >62,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is about 80℃ or less.
- 9. Please refer to the warranty statement on MEAN WELL's website at http://www.meanwell.com
- 10. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
- 11. For any application note and IP water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf
Technical drawings
Typical applications
- LED street lighting
- LED fishing lamp
- LED harbor lighting
- LED building architectural lighting
- LED greenhouse lighting
- LED bay lighting
Downloads
Certificates5
Test reports1
Catalogues1
FAQ
Can I use the HLG-120H-C350A to drive long series strings of LEDs for architectural cove lighting?
Yes. The HLG-120H-C350A outputs 350mA constant current with a CC voltage range of 215-430V, allowing very long series strings of LEDs. This makes it particularly well suited for architectural cove lighting, linear LED strips, or contour lighting where many LEDs are connected end-to-end. The adjustable output helps fine-tune current to the exact LED specification.
Is the HLG-120H-C350A suitable for driving LED modules in large-format backlit signage?
Yes. The high 215-430V CC voltage range allows you to connect many LED modules in series for large backlit sign panels without needing multiple parallel strings. At 350mA and 150.5W, it can handle substantial sign surfaces while maintaining uniform brightness across the entire string.
Can the HLG-120H-C350A power small LED arrays used in accent or display lighting?
Yes, though this driver is optimized for longer LED strings at 350mA. If your small LED array has a total forward voltage between 215V and 430V, the HLG-120H-C350A will regulate current reliably. For arrays with lower total forward voltages, a lower-voltage model in the HLG-120H-C series would be a better match.
Why does the HLG-120H-C350A have such a high output voltage compared to other HLG-120H models?
The HLG-120H-C350A is a constant current driver rated at 350mA, which is a lower current than its siblings. To deliver approximately 150W at a lower current, the voltage must be higher (Power = Voltage x Current). The 215-430V CC range means this model is designed for long series chains of LEDs rather than short, high-current parallel configurations.
What LED configurations work with the HLG-120H-C350A's 215-430V CC range?
Your LED series string's total forward voltage must fall between 215V and 430V. The exact number of LEDs depends on each individual LED's forward voltage. For example, LEDs with a typical forward voltage around 3.0V could be strung roughly 72-143 units in series, but always verify against the actual LED datasheet values.
Can the HLG-120H-C350A be mounted outdoors on a building facade for decorative LED lighting?
Yes. The series' IP65/IP67 rating protects against dust and water jets, making it suitable for sheltered outdoor locations on building facades. Its case temperature (Tcase) range of -40°C to +90°C, with derating at higher temperatures, covers year-round outdoor temperatures. For fully unsheltered mounting with direct rain, consider additional weather shielding.
What distinguishes the HLG-120H-C350A from the C350AB and C350B?
All three share the same 150.5W, 350mA, 215-430V constant current output. The C350A (this model) has adjustable output via potentiometer but no dimming input. The C350AB adds both potentiometer adjustment and 3-in-1 dimming capability (1-10V, PWM or resistance). The C350B has only the dimming input with no adjustment potentiometer.
Payment & Security
Payment methods
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
















