☎ (888) 228 9138

Over 15 years experience of providing support of MEAN WELL Power Supplies

1 5

Image shown is a representation only. Exact specifications should be obtained from the product datasheet.

Mean Well

Mean Well SDM30-12S15 DC-DC Converter - 25.5W - 9.2~18V in 15V out 1.7A

SKU SDM30-12S15
$30.30 USD
Shipping calculated at checkout.
In stock
|

Overview

SDM30-12S15 is the 15V output model of this series: rated current 1.7A, rated power 25.5W, typical efficiency 80%.

Features

  • Wide 2:1 DC input range
  • In/out capacitance1000pF
  • Protections: Short circuit / Overload/ Over voltage
  • 1000VDC I/O isolation for D/D
  • Cooling by free air convection
  • Built-in remote ON-OFF control
  • 100% full load burn-in test
  • Fixed switching frequency at 225KHz
  • Low cost
  • High reliability
  • 2 years warranty

Specifications

SDM30-12S15Specifications from the official datasheet (2024-11-22 edition)

OUTPUT

DC VOLTAGE
15V
RATED CURRENT
1.7A
CURRENT RANGE
0 ~ 1.7A
RATED POWER
25.5W
RIPPLE & NOISE (max.)Note.2
100mVp-p
VOLTAGE TOLERANCENote.3
±2.0% max.
LINE REGULATION
±1.0%
LOAD REGULATION
±1.0%
TRIM OUTPUT
±13%(Typ.) output voltage

INPUT

RATED DC INPUT
12S: 12VDC 24S: 24VDC 48S: 48VDC
VOLTAGE RANGE
12S: 9.2 ~ 18VDC 24S: 18~ 36VDC 48S: 36~ 72VDC
EFFICIENCY (Typ.)
80%
DC CURRENT
12S:3.6A 24S:2A 48S:1A
IDLE CURRENT
12S:35mA 24S/48S:30mA

PROTECTION

OVERLOAD
Above 105% rated output power Protection type : Over power limiting, recovers automatically after fault condition is removed
OVER VOLTAGE
17.25 ~ 22.5V Protection type : Shut off o/p voltage, clamping by zener diode
SHORT CIRCUIT
Protection type : Constant current limiting, recovers automatically after fault condition is removed

FUNCTION

ON/OFF CONTROL
Logic "1" or open: power on Logic "0" short to Vin-: power off

ENVIRONMENT

WORKING TEMP.
-25 ~ +85℃ (Refer to "Derating Curve")
STORAGE TEMP., HUMIDITY
-25 ~ +85℃, 0 ~ 95% RH
TEMP. COEFFICIENT
±0.03%/℃ (0~50℃)

SAFETY & EMC (Note 6)

SAFETY STANDARDS
Design refer to LVD, EAC TP TC 004 approved
ISOLATION VOLTAGE
I/P-O/P:1KVDC
ISOLATION RESISTANCE
I/P-O/P:100M Ohms / 500VDC / 25℃ / 70% RH
EMC EMISSION
Compliance to BS EN/EN55032 (CISPR32) Class B, EAC TP TC 020
EMC IMMUNITY
Compliance to BS EN/EN61000-2,3,4,6,8, BS EN/EN55035, light industry level, EAC TP TC 020

OTHERS

MTBF
8083.5K hrs min. Telcordia SR-332 (Bellcore) ; 777.2K hrs min. MIL-HDBK-217F (25℃)
DIMENSION
50.8*50.8*16mm (2"*2"*0.63") (L*W*H)
PACKING
0.1Kg; 150pcs/15.8Kg/0.94CUFT
Test conditions and notes7
  1. 1. All parameters NOT specially mentioned are measured at 12,24,48VDC input, rated load and 25℃ of ambient temperature.
  2. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1μF & 47μF parallel capacitor.
  3. 3. Tolerance : includes set up tolerance, line regulation and load regulation.
  4. 4. Short circuit not more than 60 second.
  5. 5. DC source wires ≧5cm, an input external al capacitor 47 ~ 100uF is required.
  6. 6. The power supply is considered a component which will be installed into a final equipment. All the EMC tests are been executed by mounting the unit on a 230mm*230mm metal plate with 1mm of thickness. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to “EMI testing of component power supplies.” (as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf )
  7. 7. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).

Technical drawings

SDM30-12S15 Block Diagram
Block Diagram
SDM30-12S15 Derating Curve
Derating Curve

Downloads

FAQ

Can I use the SDM30-12S15 for 15V instrumentation or analog control modules from a 9.2-18V source?

Yes, it is suited to constant-voltage 15V loads when the input feeding it stays within 9.2-18V. The output is rated at 1.7A, so the connected 15V instrumentation load needs to stay within that current and the 25.5W rating.

Is this converter appropriate for a 15V sensor interface, signal conditioner, or small industrial electronics board?

It can fit compact 15V electronics that need a regulated constant-voltage rail. For selection, the main check is that the total output demand stays at or below 1.7A.

Can the SDM30-12S15 serve as an auxiliary 15V rail inside embedded equipment?

It can work as a 15V auxiliary supply where the source rail is in the 9.2-18V range and the downstream electronics need constant-voltage output. Its compact size of 50.8 × 50.8 × 16.0 mm also helps in space-limited embedded assemblies.

Is the SDM30-12S15 meant for outdoor use or harsh ambient conditions?

The converter is rated for -25°C to +85°C operation, so it can handle a wide temperature range in protected equipment. No IP rating is listed in the provided specs, so outdoor or washdown use depends on the enclosure rather than the converter alone.

What are the main SDM30 alternatives to the SDM30-12S15 in this series?

Within the listed SDM30 range, the 12V-input versions are SDM30-12S3 at 16.5W, 3.3V, 5A; SDM30-12S5 at 25W, 5V, 5A; SDM30-12S12 at 25.2W, 12V, 2.1A; and SDM30-12S15 at 25.5W, 15V, 1.7A. The additional variants shown are SDM30-24S12 at 30W, 12V, 2.5A; SDM30-24S15 at 30W, 15V, 2A; SDM30-24S3 at 16.5W, 3.3V, 5A; SDM30-24S5 at 25W, 5V, 5A; SDM30-48S12 at 30W, 12V, 2.5A; SDM30-48S15 at 30W, 15V, 2A; SDM30-48S3 at 16.5W, 3.3V, 5A; and SDM30-48S5 at 25W, 5V, 5A.

Payment & Security

Payment methods

  • American Express
  • Apple Pay
  • Bizum
  • Diners Club
  • Discover
  • Google Pay
  • Mastercard
  • MB WAY
  • PayPal
  • Satispay
  • Shop Pay
  • Visa

Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.

{ "id":8659343769920, "variants" :[{ "context":"default", "variant_id": 46634856579392, "sku":"SDM30-12S15", "inventory_qty" : 58, "customer" :true, "custom_html" :"\u003cdiv class=\"price\"\u003e\n \u003cdiv class=\"price__default\"\u003e\n \u003cstrong class=\"price__current\"\u003e$30.30\u003c\/strong\u003e\n \u003cs class=\"price__was\"\u003e\u003c\/s\u003e\n \u003c\/div\u003e\n\n \u003cdiv class=\"unit-price relative\" hidden\u003e\u003cspan class=\"visually-hidden\"\u003eUnit price\u003c\/span\u003e\u003cspan class=\"unit-price__price\"\u003e\u003c\/span\u003e\u003cspan class=\"unit-price__separator\"\u003e \/ \u003c\/span\u003e\u003cspan class=\"unit-price__unit\"\u003e\u003c\/span\u003e\u003c\/div\u003e\n\n \u003cdiv class=\"price__no-variant\" hidden\u003e\n \u003cstrong class=\"price__current\"\u003eUnavailable\u003c\/strong\u003e\n \u003c\/div\u003e\n\n \u003c\/div\u003e", "volume_html" :"\u003cvolume-pricing class=\"parent-display inside_product_form\" id=\"volume-pricing-main\" \u003e\u003c\/volume-pricing\u003e" } ] }
Mean Well SDM30-12S15 DC-DC Converter - 25.5W - 9.2~18V in 15V out 1.7A
Mean Well

Mean Well SDM30-12S15 DC-DC Converter - 25.5W - 9.2~18V in 15V out 1.7A

$30.30 USD

SDM30-12S15 is the 15V output model of this series: rated current 1.7A, rated power 25.5W, typical efficiency 80%.

Features

  • Wide 2:1 DC input range
  • In/out capacitance1000pF
  • Protections: Short circuit / Overload/ Over voltage
  • 1000VDC I/O isolation for D/D
  • Cooling by free air convection
  • Built-in remote ON-OFF control
  • 100% full load burn-in test
  • Fixed switching frequency at 225KHz
  • Low cost
  • High reliability
  • 2 years warranty
View product

  • Call us

    (888) 228 9138

  • Email us

    contact@wellforces.com

  • Business Hours

    Mon-Fri
    EST 9:00am-5:30pm

  • Wholesale and Trade Account

    Let's grow together
Back to top